Owner manual

-18-
5.7 Web GUI Control
To access the Web GUI Control capability, rst make certain that the DVI-3571a
unit and the control system being used are both connected to an active network.
The DVI-3571a may be connected to the network using the Ethernet port on the
rear panel. Open a web browser on the controlling PC or laptop and enter the
Switcher / Scaler’s IP address into the web address entry bar. By default, the unit
is set to DHCP mode and will be assigned an IP address by the network. This
assigned IP address can be found by navigating through the OSD menu to the
Information Menu. However, if the unit is set to Static IP Mode, then the factory
default IP address is 192.168.0.1. The browser will load the DVI-3571a Web GUI
Control page (see below for reference). All functions of the unit are controllable
from this single screen.