Manual

DVI-7311

Single-Link DVI

Fiber Optic Extender, 4x LC

Quick Start Guide

Introduction

DVI-7311 is a Fiber Optic Extender designed to transmit single-link DVI signals over optical ber

cables at distances up to 500 meters (1,640 ft.). This extender provides exceptional signal delity and

supports a wide range of input resolutions. The unit consists of an optical transmitter module that

converts the DVI input signal into high-speed light pulses for transmission over four (4) detachable

multi-mode glass bers and an optical receiver module that converts the light pulses back to a DVI

signal for display on a monitor or projector. A programmable memory chip in the transmitter unit

captures and stores the EDID from the connected display, thereby eliminating the need for copper

cables. These features make the DVI-7311 the ideal solution for any application that demands

awless image quality from DVI signals that must be extended over very long cable distances.

Typical Application

DVI-7311 Single-Link DVI Fiber Optic Extender, 4x LC

DVI-7311-RX

Receiver

DVI Port

DVI-7311-TX

Transmitter

DVI Port

1 2 43 1 2 43

AC Power

Adapter

Optional

AC Power

Adapter

PAGE 1
DVI-7311 Single-Link DVI Fiber Optic Extender, 4x LC Quick Start Guide Introduction DVI-7311 is a Fiber Optic Extender designed to transmit single-link DVI signals over optical fiber cables at distances up to 500 meters (1,640 ft.). This extender provides exceptional signal fidelity and supports a wide range of input resolutions.
PAGE 2
a 3 4 5 1 DVI-7311-TX Front View 2b 2a 1 5 4 3 2 DVI-7311-TX Rear View 2b
PAGE 3
Single-Link DVI Fiber Optic Extender, 4x LC Quick Start Guide DVI-7311 1. DVI Connector DVI-7311-TX connects to source, DVI-7311-RX connects to display 2a. EDID LED (Top side) Illuminates Blue when EDID has been read successfully 2b. POWER LED (Bottom side) Illuminates Red when DC power is applied 3. Fiber Optic Connectors 4x LC optical connectors for multi-mode fiber optic cables 4. DC IN Connector Connect the External AC Power Adapter to this receptacle 5.
PAGE 4
Learn EDID Button Insert a stylus to press the Learn EDID Button Instructions for Learning the EDID from a Display 1.) Apply power to the display. 2.) Connect the DVI-7311 Transmitter unit to the display’s DVI input port. 3.) Connect the External AC Power Adapter to the Transmitter unit. 4.) Press the Learn EDID button (page 2 - #5) by manually inserting a stylus into the side of the Transmitter unit. If the EDID is properly read, the BLUE Indicator LED (page 2 - #2a) should illuminate once. 5.