Software Owner manual

NDVR Server Manual

2.2.1 Camera setup

【Selected Camera】To set the parameters for a camera, select the

camera from the drop-down list. The cameras you can select are only the

cameras of the local board card except for IP Cameras. For IP Camera, you

should set it remotely in IP Camera setup.

【Camera Description】Input the description for easy identification. OSD

text can support any languages，it can put any language in camera

description edit blank ,and then press the button to set proper color (it does not

support white) as below:

【Camera Type】Select camera type from drop-down list. Users can

choose from PAL and NTSC.

【Camera】Enable or disable selected camera.

【Sub Stream Frame Rate(fps)】Set the frame rate of the Sub Stream.

VBR allows each frame to be recorded at a dynamic bit rate depending on

the image complexity, activity and color.

CBR allows each frame to be recorded at fixed bit rate, regardless the

scene activity. In many cases, this limits detail (resolution). The benefit of CBR

is its ability to accurately estimate the total video capacity.

【Frame Rate(fps)】Set the recording rate for selected camera. For

Frames per Second (fps), the frame rate should be from 1 to 30 fps. While

image size is set ―704*576‖, the frame rate should be set around 1 to 15 frame.

【Sub Stream Image size】Select image resolution to the Sub Stream.

When you set the【Image Size】As 4CIF(704*576), this configuration is not

available for HC series card.

【Image Quality】Set the quality of the image to be recorded. Select from

Poorest, Poor, and Medium, Very good and best.