Software Owner manual

NDVR Server Manual

Cameras are not included. For IP Camera, you should set it remotely in IP

Camera setup.

【PTZ Port】Select PTZ connecting port, when you do not use PTZ port,

please choose ―------‖.

【NDVR Keyboard COM Port】Select a connecting port for NDVR

keyboard. If you have chosen COM1 for DI/DO Port, and you choose COM1

again for NDVR keyboard, then, DI/DO Port will be changed to another port. If

you want to know more details for NDVR keyboard, please refer to NDVR/NVR

Keyboard Control Manual.

【PTZ Protocol】Selects the PTZ protocol for the PTZ camera.

【PTZ Address】Set the camera ID number of the PTZ camera being

controlled.

Note:

The PTZ camera has a dipswitch to set the PTZ address. The PTZ

camera ID number must be matched with the number of this dipswitch.

【PTZ Baud rate】Select PTZ Baud rate for the PTZ camera.

【PTZ Position】 Select the installation mode of the PTZ according to its

installation mode.

Note:

1) PTZ position will influence PTZ control. E.g.: if you set it as obverse

and press left, then it will turn left. If you set it as inverse and press

left, then it will turn right;

2) If there is (H) after the PTZ protocol, it has the high speed of Preset

function. If there is no (H), it only has ordinary functions;

3) The PTZ address will be sent as a message option. Take care that

some addresses begin from 0. That is to say，when the address

number is 1, the real address is 0. So we must set it according to their

relations.

2.4.2 Motion detection relay

【DO Port】【 DO Port Name】Select a DO port and set its name to identify

the various DO port. It will be shown as a tip when the mouse moves closely or

above the DO button in NDVR Server or NVR Client.

【Camera alarm detected In】Selects camera to be set from dropdown

list.