User's Manual

1-2. Installation directions
4
About Navigation System
Navigation System
Warning
Connect the wires properly by referring to ŔInstalling productŕsection.
Otherwise, malfunction or accident may occur.
Caution
Use only the connection cable for vehicle that was provided at the time
of product purchase to ensure stable system operation.
Warning
Do not install the product in a position where driving can be interfered
or driverœs field of vision can be blocked.
Caution
This product must be used with 12V car power only. Do not use 24V power.
Caution
Some functions of this system are disabled for driverœs safety when the car is in
motion. Remove the test jack installed in the safety terminal and connect the
hand brake cable to the car hand brake. If this cable is not connected, only
Ŕaudioŕwill be supported in Aux mode.
Caution
Connect the Aux cable such as line out or A/V in after turning the power off.
If the power is on while connecting the cable, the product can be damaged.
Caution
Do not install the product in a place with water, humidity, vapor, dust, oil, or smoke.
Warning
Install the product in a position that does not interfere with driving or
safety devices like an air bag.
Caution
If you donœt use the product for a long time after purchasing this product, car
position sensing time can be prolonged, since the GPS antenna backup battery
can be discharged.
In this case, charge the battery for 2 ~3 hours while using the navigation system.
Caution
Do not put objects that interfere with GPS signal reception around the GPS
receiver. Radio interference may occur.
Caution
Do not install electronic products that generates heavy electromagnetic waves
like a radio transmitter around the GPS antenna.
Caution
GPS reception can be blocked if the car windshield is specially tinted.