User's Manual

1-3. Upgrade directions
1-4. Troubleshooting
1) Touchscreen does not work
If you cannot set up the touchscreen in the Setup menu due to wrong setting, use the remote
controller instead.
Ș Press the [Initial Screen] button on the remote controller to open the main menu screen.
Ș Press the [SUB-T] ō> [ZOOM] ō> [INFORMATION] ō> [REPEAT] button sequentially
in the DVD box of the remote controller to open the Touch Setting screen.
Ș Press the 5 cross marks using the test jack or touch adjustment rod, according to the
instructions displayed on the screen.
Ș Press the screen once to close the Touch Setting screen.
2) The LED turns on or flashes in red during self-diagnostic:
In addition, when the temperature inside the car is too high or low, the red LED flashes. In this
case, follow the steps below.
Ș Turn the product power off and ventilate the car to get normal temperature.
Ș Turn the power on after a little while and observe the LED color.
Ș If the red LED still flashes in normal temperature, contact customer service.
5
About Navigation System
Ș Do not connect 12V power when connecting ActiveSync.
Ș Depending on the USB memory product, the USB sensing time may vary or sensing
may fail.
Ș Only the USB memory with FAT32 format is supported.
Format the USB memory as FAT32 before using it.
Navigation System
Park the car in a safe place for touchscreen setting.
Basic Operation
Caution