User's Manual

46
Additional Information
Additional Information
T roubleshooting
Cause
The power cord is disconnected.
No disc in inserted.
The equipment connected with the audio
cable is not set to receive DVD signal
output
The audio cables are not connected
securely.
The power of the equipment connected
with the audio cable is turned off.
The digital audio output is set the wrong
position.
The TV is not set to receive DVD signal
output.
The video cable is not connected
securely.
The disc is dirty.
No disc is inserted.
An unplayable disc is inserted.
The disc is placed upside down.
The disc is not place within the guide.
A menu is on the TV screen.
The rating level is set.
Symptom
No power
The power is on,
but the DVD player
doesn't work
No sound
No picture
The playback picture
is poor.
Correction
Plug the power cord into the wall outlet
securely
Insert a disc. (Check that the DVD or audio
CD indicator in the DVD display is lit.)
Select the appropriate video input mode on
the TV so the picture from the DVD player
appears on the TV screen.
Connect the audio cable into the jacks
securely.
Turn on the equipment connected with the
audio cable.
Set the Digital Audio Output to the correct
position, and then turn on the DVD player
again by pressing the POWER button.
Select the appropriate video input mode on
the TV so the picture from the DVD player
appears on the TV screen.
Connect the video cable into the jacks
securely.
Switch TV to appropriate mode using the
TV mode using the TV MODE button on
the remote control.
Check if you pressed the AUDIO ONLY
button.
Clean the disc.
Insert a disc. (Check that the DVD, or audio
CD indicator in the DVD display is lit.)
Insert a playable disc.
(Check that the DVD,
or audio CD indicator in the DVD display is lit.)
Place the disc with the playback side down.
Insert the disc correctly inside the guide.
Press the SETUP button to turn off the
menu screen.
Cancel the rating function or change the
rating level.