User guide

2-7
Server Setup
2
1
3
4
5
I
A
Setting the IP Address of the Spycer Software
To get the full functionality for the DVS system the Spycer software is
already installed. When changing the IP address of the network port it
should be configured correctly as well. For this start the Spycer software
on the VENICE server and make sure that it is set to the following:
– The IP address of the network port that Spycer should use for the
SpycerNet must be set. Normally it is the same as configured previ-
ously (see section “Configuring the IP Address of the Network
Port” on page 2-6).
– The local content management must be enabled.
– The local audio and video storage location(s) of the VENICE server
(see section “Information about the Main Storage” on page 2-7)
must be set as watch folders.
With this the Spycer software has been set up correctly and afterwards
the user interface of Spycer can be closed.
2.3 Information about the Main Storage
The following table provides some information about the main storage:
When the Spycer software is started for the first time, the initial
setup of the application may be launched. In order to run Spyc-
er this setup should be concluded, thereby enabling the follow-
ing configurations.
For further information about Spycer and its configurations see
the “Spycer” user guide.
File system: SNFS (StorNext File System)
Location: /media/venice-vol0/
License file: /user/cvfs/config/license.dat