User guide

3-1

Client Software Installation

This chapter describes how to install the VENICE client software on a

client system for a remote control of the VENICE server. With this you

can place the hardware of VENICE at any location you like and still have

full control over it. The installation will be described for each supported

operating system separately.

3.1 Notes about Spycer

For any data management with a VENICE client software the latest

Spycer application by DVS must be installed as well (see section “Sys-

tem Requirements” on page 1-5 and section “Setup Concept and

Structure of VENICE” on page 2-2). After its installation it must be con-

figured appropriately so that it can connect to the Spycer software on

the VENICE server (SpycerNet):

When the software is started for the first time, the initial setup of the

application will be launched. Then set at least the IP address of the port

on the client system that is connected to the network to enable the

SpycerNet. On clients the local content management of Spycer can be

disabled if not required.

For information about how to install Spycer as well as its con-

figurations see the “Spycer” user guide.