User guide

4-9

Client Software Configuration

4.2.6 Sync Settings

The Sync settings set the synchronization of in- and output video sig-

nals for the connected video channel.

Figure 4-7: Sync settings

It provides separate settings for the sync reference and the analog out-

put.

Sync Reference

The sync reference settings set the synchronization of the input thereby

determining the sync output:

Type Determines the type of sync for the input

thereby determining the sync output. Usually,

the video channel runs in a non-genlock mode,

i.e. an internal synchronization is performed

(Internal). To set the video channel into an

analog genlock mode connect a signal to its

reference input and select an appropriate sync

type here (e.g. Bilevel or Trilevel). If a

synchronization should be performed via the

signal received on the SDI inputs, select the set-

ting Digital.

H phase Adjusts the horizontal phase of the sync output

signal relative to the input sync signal. The out-

put signals will be altered accordingly, i.e. the

time base of the output signals will be generally

altered. The value is for SD video rasters in half-

pixels, for all others in full pixels.