User guide

4-14
VENICE Client Software User Guide
y Use the player controls and the video overlay to search for a certain
position or to play out the material of the externally connected
device.
With this the external device can be controlled and you can, for exam-
ple, verify the material. However, for an autoedit record with the
VENICE server an in- and outpoint should be set as well, which will be
explained next:
y Use the player controls and the video overlay to search for the exact
position for the inpoint in the material of the externally connected
device.
y Once the external device shows the correct position, press the IN
button to set the inpoint to this position. Alternatively, you can
enter the respective position manually in the entry field of the
inpoint afterwards pressing [Enter].
y After that use the controls to move to the desired outpoint in the
material.
y Click on the button OUT or enter the position in the respective
entry field to the right of the OUT button and afterwards press
[Enter].
With this the selected in- and outpoint will be shown in the associated
entry fields of the player controls and the duration will be set accord-
ingly.
When this is finished you can, for example, start an autoedit record as
described in section “How to Autoedit Record with the VENICE Server”
on page 4-15.
4.6.2 How to Crash Record with the VENICE Server
In the ingest mode you can perform a crash record with the VENICE
server. It will then immediately record, according to your settings, the
signal that is present at its input, e.g. the content that is played out
manually with an external device (see section “How to Control the Ex-
ternal Device” on page 4-13).
To initiate a crash record perform the steps as described below:
y If necessary, configure the input format so that it matches the signal
present at the server’s input with the Input settings items (see sec-
tion “Configuring the Input Settings” on page 4-2).
y Determine a file name and path for the file(s) to be recorded with
the Destination items as described in section “Selecting the Stor-
age Location and File Name” on page 4-5.
Alternatively, you may also specify one of the entries for in- or
outpoint and afterwards set the duration of the play-out.