Installation guide

DVTel CF-4221-00 Fixed IP Camera User & Installation Guide
9
4.3 Camera Initial Configuration
To Make the Camera Initial Configuration
1.) Plug the CAT5 cable into the camera Ethernet port and if the network doesn’t provide
PoE 802.3af, wire a properly rated AC 24V/DC 12V power supply into the terminal-
block plug and plug it into the power terminals. See polarity noted in HD Series
Connections image.
2.) Do one of the following:
 Copy and run the DeviceSearch.exe from the included CD.
 From the Latitude Sidebar, run the Unified Configurator by selecting
Applications  Device Configuration Tool and then on the Unified
Configurator screen, click DVTel HD Series.
3.) In the DeviceSearch application, click Device Search and do the following:
a.) In the search results, click on the camera to select it.
b.) Right-click and select from the shortcut menu Network Setup.
c.) In the dialog that appears, select Static IP
d.) Enter the IP Address, Gateway and Netmask (network mask) as
needed and click OK.
4.) Disconnect the Ethernet cable and if you are using a power supply, turn off the power
to the power supply and unplug it.
The camera is ready for deployment in a site installation (mounting).
Note: The camera can be connected to a PC for bench installation via an Ethernet
cross-cable.
Note: The camera default IP Address is 192.168.0.250 and default subnet mask is
255.255.255.0.
Tip: A camera setup adapter, such as Veracity Pinpoint, can be used to connect a
laptop directly to the camera when using POE.