Installation guide

DVTel CF-4221-00 Fixed IP Camera User & Installation Guide

4 Indoor Installation

Please read the instructions provided in this chapter thoroughly before installing the DVTel

CF-4221-00 Fixed IP Camera.

The following are additional consideration for an indoor installation.

 There must be a fuse or breaker at the starting point of the electrical wiring

infrastructure.

 For indoor installations, such as industrial applications, the CF-4221-00 must be

protected from elements, such as damaging fumes, metallic dust, extreme

temperatures, soot, moisture, over spray, etc.

 CF-4221-00 cameras should not be placed near or on radiators and heat sources.

 All electrical work must be performed in accordance with local regulatory

requirements.

Related Links

Power and Ethernet Cable Connection

Lens Mounting

Camera Initial Configuration

Mounting the DVTel CF-4221-00 Fixed IP Camera

Adjusting and Framing Up the Camera View

4.1 Power and Ethernet Cable Connection

Power Connection

Make sure the camera’s power cable is properly connected; refer to the pin definition table in

section Camera’s Connectors. If using Power over Ethernet (PoE), make sure Power Sourcing

Equipment (PSE) is available on the connected network.

All electrical work must be performed in accordance with local regulatory requirements.

Ethernet Cable Connection

Use of Category 5 Ethernet cable is recommended for network connection; to have best

transmission quality, cable length shall not exceed 100 meters. Connect one end of the

Ethernet cable to the RJ-45 connector of the CF-4221-00 camera, and the other end of the

cable to the network switch or PC.

NOTE: You can use an Ethernet crossover cable when connecting the CF-4221-00

directly to the PC.