Installation manual

Installing and Connecting the Unit
13
3.3 Resetting the Unit
The unit can be reset as follows:
 Reset Using the Reset Button (page 13)
 Reset by Removing the Power Supply (page 13)
3.3.1 Reset Using the Reset Button
The unit has a reset button located on the power connection panel of the unit. See Figure 3: trk1 Power
Connection Panel.
To reset a unit using the Reset button
1. Insert a small pointed object into the hole labeled Reset on the power connection panel of the
unit.
2. Press in and release the button within 5 seconds. The unit resets with its previous settings.
3.3.2 Reset by Removing the Power Supply
The unit can be reset by turning off the power and then turning it on again.
To reset a unit by removing the power supply
1. Turn off or disconnect the power to the unit.
2. Turn on or reconnect the power to the unit. The unit restarts with the previous settings.
3.4 Solo Setup
The Solo Setup function enables you to install and setup a camera at the remote site without requiring
another person’s assistance. With this function, you can:
 Use the camera to record a set of snapshots of the scene while the user is moving around the
camera field of view
 Move around within the camera’s field of view
 Use the recording of his movement to setup the depth by marking his height on the camera’s
field of view
For instructions on how to use the Solo Setup, see page 19 in the Appendix.