Installation manual

IOI-XTRK-10D Installation Manual

To help ensure safety and to help reduce risk of injury or damage, observe the following:

Warning:

1. Only qualified trained personnel should service and repair this equipment.

2. Observe local codes and laws and ensure that installation and operation

are in accordance with fire, security and safety standards.

Electrical Safety Notice and Warnings

Warning:

1. Read the installation instructions before you connect the unit to a power

source.

2. Electrical safety should always be observed. All electrical connections must

be performed by a certified electrician.

3. If you use an extension cord with this system, make sure that the total

ampere rating on the products plugged into the extension cord does not

exceed the extension cord ampere rating.

4. To avoid possible shock hazards or damaging the unit, ensure that the

positive and negative of the power leads are properly connected to the

terminal block connector before plugging it into the unit or turning on the

power source.

5. In the following situations, the electric power should be turned off

immediately and appropriate repairs, replacements or remedies should be

taken if:

 The power line is damaged, frayed or shows heavy wear.

 The unit has been physically crushed or deformed.

 The unit has been exposed to water.

 The unit has been exposed to, or shows signs of damage from, fire,

intense heat, heavy smoke, fumes, or vapors.

 Electrical connections of the unit become abnormally hot or generate

smoke.

 The unit has been dropped, damaged or shows signs of loose internal

parts.

 The unit does not operate properly.

Caution:

To avoid damage from overheating or unit failure, ensure that there is sufficient

temperature regulation to support the unit’s requirements (cooling/heating).

Operating temperature should be kept in the range 0° to 50°C (32° to 122°F), with

no more than 95% non-condensing humidity.