Installation manual

trk-101-P Installation Manual
6
To assemble units in a rack mount panel:
1. Remove the nut and washer from each of the two video connectors on the video connection
panel of the unit.
Figure 5: trk-101-P with Nuts Removed
2. Attach each unit to the rear side of the rack mount panel by inserting it through the holes as
shown in Figure 6.
Figure 6: Inserting Units into Rack Mount Panel
3. Fasten each unit using the nuts and washers removed in step 1, making sure to first place the
washer on each video connector before tightening the nut on the video connector.
4. Repeat steps 1 through 3 for each of the units you want to assemble on the rack mount panel
(up to 10 units can be assembled per panel).
5. Attach the rack mount panel to a 19" rack.