Installation manual

Installing and Connecting the Unit

This section describes how to install and connect the unit and includes the following sections:

 Installing the Unit (page 5)

 Connecting the Unit (page 7)

 Resetting the Unit (page 12)

Note:

After connecting the unit, proceed to configure the unit as described in the HTML Edition Units

User’s Guide.

3.1 Installing the Unit

The unit can be installed and mounted next to the camera (inside the camera enclosure).

Alternatively, the unit can be installed inside an equipment room on a shelf or in a rack using the rack

mount panel that is available as an optional accessory.

When installing the unit make sure that:

 It is securely tied down and cannot be easily dislodged

 Operating temperatures, at all times, are kept between the minimum/maximum allowed

 Proper ventilation is provided so that the air is free to circulate around the unit

 The unit is protected from direct weather conditions (for example, sunlight, rain, dust, and so on)

Caution:

To avoid damage from overheating or unit failure, do not block the vents of the unit and assure,

there is sufficient temperature regulation to support the unit’s requirements (cooling/heating).

Ambient operating temperature should be kept in the range 0° to 50°C (32° to 122°F).