Installation manual

Installing and Connecting the Unit
13
3.3.1 Hard Reset Using the Reset Button
The unit has a Reset button located on the power connection panel of the unit. (See Figure 3: trk-101
Power Connection Panel)
To reset a unit using the Reset button:
7. Insert a small pointed object into the hole labeled Reset on the power connection panel of the
unit.
8. Press in and release the button within 5 seconds. The unit resets to its last settings and the LED
flashes green.
3.3.2 Hard Reset by Removing the Power Supply
The unit can be reset by turning off the power and then turning it on again.
To reset a unit by removing the power supply:
9. Turn off or disconnect the power to the unit.
10. Turn on or reconnect the power to the unit. The unit restarts with the last settings.
3.4 Night Mode Max FPS
A new setting, Night Mode Max FPS, has been added to the Setup>Camera>Video Settings>Advanced tab.
This setting can be implemented only via the camera’s web interface. For instructions how to use the Night
Mode Max FPS setting, see page 19 in the Appendix.