Installation & Assembly

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPTEMBER, 2014
PREPARATION
1. Shut o the power at the circuit breaker and
remove existing xture, including the mounting
hardware.
2. Carefully unpack your new xture and lay out all the
parts on a clear area. Be careful not to lose any small
parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screws (C1) from the xture.
4. Place the glass (H1) into the xture frame (E1) and
secure it using spring clips.
CONNECTING THE WIRES (Fig. 2)
5. Connect the xture wires to junction box wires as
shown in Fig. 2, making sure that all wire connectors
(A1) are secured. If your outlet box has a green or bare
copper ground wire, connect the xture’s ground wire
to it. Otherwise, connect the xture’s ground wire
directly to the mounting plate (D1) using the green
screw provided. After wires are connected, tuck them
carefully inside the junction box.
6. Secure the mounting plate (D1) to the junction box
(F1) using the junction box screws (B1).The side of the
mounting plate marked “GND” must face out.
MOUNTING
7. Adjust the length of screw (G1) on the mounting
plate (D1).
8. Place the xture’s back plate (I1) over the mounting
plate (D1) and secure with the screws (G1) through
key holes in xture back plate (I1).
9. Secure the xture frame (E1) to the xture back
plate (I1) using the mounting screws (C1).
100%10% DIMMING
COMPATIBLE WITH THE FOLLOWING ELECTRONIC
LOW VOLTAGE ELV DIMMERS
Brand Model
LUTRON SELV-300P
LUTRON DVELV-300P
LEVITON MLE03-1
INSTALLATION INSTRUCTION
ASTORIA - dwelLED™
FM-7013
F1
A1
D1
G1
B1
I1
H1
C1
E1
FIG.1
Junction box
Wire connectors
Mounting plate
Screws
Junction box screws
Back plate
Fixture Glass
Mounting
Screws
Fixture
frame
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring