Installation & Assembly

dweLED.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Ave
Ontario, CA 91761
dweLED retains the right to modify the design of our products at any time as part of the company's continuous improvement program. Jan 2019 2
INSTALLATION INSTRUCTIONS
409 –LED PENDANT
PD-40901，PD-40902
PREPARATION
1. Shut off the power at the circuit breaker and remove existing
fixture, including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a
clear area. Be careful not to lose any small parts necessary for
installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screw (B) from the fixture.
4. Drill holes in the wall aligned with the key holes located on the back
plate. Insert the plastic anchor (D).
5. Secure the mounting back plate to the junction box using the
screws provided with the junction box. Fasten the back plate to the
wall with the plastic anchors using the wood screws (C) provided.
NOTE: The side of the mounting plate marked “GND” must face
out.
CONNECTING THE WIRES (Fig. 2)
6. Adjust the fixture wire length by pushing the cable gripper on the
canopy and pulling the wire as desired.
a. Retract the wires close to the desired length within the
canopy before securing the fixture in place.
NOTE: Using the cable gripper to adjust more than 18” of wire
length is not recommended.
WARNING: Shortening the cables without professional help or
electronic background is not advisable. Any modifications to the
fixture will result in voiding the warranty of the product.
7. Connect the driver’s input/output wires with junction box wires as
shown (Fig. 2). Make sure that all wire connectors (A) are secure. If your outlet box has a green or bare copper ground wire,
connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground
wire directly to the back plate using the green screw provided. After wires are
connected, tuck them carefully inside the junction box.
NOTE: This fixture features electronic low voltage (ELV) or 0-10V dimming
capabilities. See notes below for specific dimming wiring information.
COMPLETING THE INSTALLATION
8. Secure the fixture to the mounting back plate using the mounting screw (B).
DIMMING WIRING INSTRUCTIONS (Fig. 3)
9. To utilize ELV dimming: use black (hot), white (neutral) and bare copper ground
wires (ground).
10. To utilize 0-10V dimming: use purple (dim+), gray (dim-), black (hot), white
(neutral) and bare copper ground wires (ground).
Fig. 2 Wiring