Installation & Assembly

2WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the mounting screw (C1) from the xture.
4. Connect the Drivers’ input wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured.
If your outlet box has a green and bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’ ground
wire directly to back plate using the green screw provided.
*Requires Driver to be recessed within the junction box.
MOUNT ON JUNCTION BOX (Fig. 1)
5. Drill a hole in the wall aligned with the key holes located in the mounting
plate, insert the plastic anchor (D1).
6. Secure the mounting back plate to the junction box using junction box
screws (B1), fasten it to the wall using the wood screw (E1).
The side of the mounting back plate marked “GND” must face out.
7. Secure the xture to the mounting back plate using the mounting screw (C1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
FIG.1
Wood Screw
Wire Connector
Plastic Anchor
Ground Wire
Junction Box
LED Driver
Mounting Back Plate
Edge-Lit Acrylic
Junction
Box Screw
Mounting
Screw
Canopy
B1
C1
E1
A1
D1
INSTALLATION INSTRUCTION
596 - LED Bath
WS-59623, WS-59629, WS-59639
Back Plate Dimensions
9 1/2"
1 3/4"
4 1/4"
Ø 3 1/2"
Ø 2 3/4"
7 1/4"
1 3/8"