Manual
Table Of Contents
- TABLE OF CONTENTS
- GETTING STARTED
- INSTALLATION 4
- DIMENSIONS
- INPUT SELECTION
- LOGIC JUMPER SELECTION
- FRONT PANEL KEY FUNCTIONS
- NOTATION CONVENTIONS FOR THE MENUS
- THE HOME DISPLAY
- Operation of Self Tune® Function
- Theory of Operation
- Program Setup and Operation
- METHOD FOR SET UP OF A HEAT / COOL CONTROL WITH SELF TUNE
- Programming and Operation
- for Ramp / Soak feature
- Theory of Operation
- Program Setup
- Ramp / Soak Operation
- MENU SELECTIONS
- PRIMARY MENU
- SECONDARY MENU
- SECURE MENU
- DIAGNOSTIC ERROR MESSAGES
- CONFIGURATION MENU
- SPECIFICATIONS
Rev. 10/98 27 949-1239-3
bAUd Communications baud rate (992): Select 300, 1200, 2400, 4800,
9600, 19.2, 28.8, or 57.6. This number must match the baud rate
used by the host computer. The data format is 8 bits, 1 stop bit,
No parity.
nAt No Activity Timer (992): Select OFF to 99. If a number is set, the
control will expect access by the host computer. If no access is
detected within that time, the control will indicate an error, CHEC
LorE and go to the set point indicated by CFLt.
CFLt Communication Fault Mode (992): Select 1 or 2. 1 = On
Communication fault use local Set Point. 2 = On Communications
fault use CFSP.