Owner's manual

43 | P a g e
Enable Engineering Units
The Enable engineering units on this device option indicates if the units programmed into the
device should be displayed when data is downloaded.
Prompt for unit selections on download
The Prompt for unit selections on download option allows the stored information to be edited each
time the data is uploaded.
Portable Units
The Portable Units tab contains description, label, gain, and offset fields. The description field is
used to enter the full name of the parameter to be displayed in the software. Examples of this are
Volts, Milliamps, pH, Gallons, etc. This name is displayed on the graph and data table as the
description of the data.
The label field is used to enter the label of the parameter that is to be displayed in the software.
Examples are V, mA, pH, G, etc. The gain and offset fields are the equivalent of the "m" and the "b"
respectively in the "Y = m * X + b" equation. X is the raw data from the device and Y is the data
displayed by the software.
Device Units List
The Device Units List tab shows all channels and their corresponding unit.