User guide

Multi Process Meter Instruction Manual
19
Connectors Labeling
The connectors’ label, affixed to the meter, shows the location of all
connectors available with requested configuration.
Warning!
Do not connect any equipment other than Dwyer
Instruments, Inc.’s expansion modules, cables,
or meters to the RJ45 M-LINK connector.
Otherwise damage will occur to the equipment
and the meter.
Figure 7. Connector Labeling for Fully Loaded Meter
Power Connections
Power connections are made to a two-terminal connector labeled
POWER on Figure 7 on page 19. The meter will operate regardless of DC
polarity connection. The + and - symbols are only a suggested wiring
convention.
Figure 8. Power Connections
AC or DC
POWER
Required External Fuse:
5 A max, 250 V Slow Blow
POWER
+
-