User guide

Multi Process Meter Instruction Manual

Reset Meter to Factory Defaults

When the parameters have been changed in a way that is difficult to

determine what’s happening, it might be better to start the setup

process from the factory defaults.

Instructions to load factory defaults:

1. Enter the Advanced Features menu. See Advanced Features

, page 67.

2. Press Up arrow to go to

Diagnostics menu

3. Press and hold Right arrow for three seconds, press

Enter when display flashes

reset.

Note: If Enter is not pressed within three seconds, the display

returns to the

Diagnostics menu.

4. The meter goes through an initialization sequence (similar as on

power-up), and loads the factory default settings.

Note: The dual-scale selection for some level applications (d-SCAL) is

not reset to the single scale factory default. This can be changed

using the Setup – Input menu.