Instruction Manual

December, 2004 Page 2 of 8 949-0529 Rev. 2

Getting Started

1.) Using a small screwdriver, ball point pen, etc. set the Input Mode Switch

(SW-1) on the side of the unit for the type of input to be used. Set the

Input Range Switch (SW-4 for the input range desired (see Input Pro-

gramming on page 3).

2.) Set the Output Switch (SW-2) for the output responses required (see

Output Programming on page 4).

3.) Mount unit into panel. (see Mounting on page 5).

4.) Connect unit to input signal, output signal, and power wiring (see Wir-

ing on page 5).

5.) Check calibration (See Calibration on page 6).

Operation description is on page 6

Specifications are on page 7.