User Manual

12of30 MN890570 RevA
ULSX‐CALCONFIGURATION(continued) StepSeven

RelayFail‐Safe:Thisfeatureallowsyoutoselectthefail‐safestatefor
the relays.When the sensor regains signal, the output current will
revertbacktothecurrentlevelcondition.
o Relays Off ‐ The relays will revert to the OFF state.Appears
whenSwitch/AlarmsOnlyisselected.
o RelaysOn‐TherelayswillreverttotheONstate.
AppearswhenSwitch/AlarmsOnlyisselected.
o Hold State‐The relay(s) will remain in the same state as the
lastechodetected.Whenthesensorregainssignal, therelays
willreverttothelevelwhenthesignalwasregain.
o Pump/Valves Off ‐ The relays will revert to the OFF state.
Appearswhen1‐Pump/Valveor2‐Pumps/Valvesareselected.
o Pump/Valves On ‐ The relays will revert to the ON state.
Appearswhen1‐Pump/Valveor2‐Pumps/Valvesareselected.
o Not Applicable – Appears when this function is not available
(suchaswhenTransmittersOnlyareselected).
Note:Rightclickonanymenuthatyoumayhavequestionsontoopenthehelpmenu.
Note:Toreset,presstheClearScreenbutton.




