User Manual

Rev5 MN890570 27of30
APPENDIX StepEleven
Updating Transmitter Firmware:ULSX‐CAL software can alsobeused to update firmware inside the Series
ULStransmitter.Thisfeatureallowsthetransmittertobeupdated whennewfeaturesareadded.Firstopen
ULSX‐CALwithanSeriesULStransmitterconnectedandthelatestversionofULSX‐CALinstalledtoyourPC.

Clickonthe“Updates”Tabandthenclickon“SelectProgram”toselectthefirmwareupdate.

SelectthelatestversionofthefirmwarefileandclickonOK.

Confirmthattheaddressiscorrectandthenclickon“UpdateSensor”tobeginthefirmwareupdate.Thisstep
should
take less than 1minute.Youcan follow the progress withthestatus bar to the rightoftheUpdate
Sensor button.When completed, click on the Configuration tab to configure the transmitter.Remember,
whenthefirmwarehasbeenupdated,theunitwillreturntoitsoriginalfactorysettings.

Ifthereisacommunicationinterruptionduringtheupdate,theprocesswillstop.ItisOKtoclickon
UpdateSensoragaintostarttheprocessoveragain.
