User Manual

28of30 MN890570 RevA
TROUBLESHOOTING StepTwelve
FactoryDefault:Pressingthe“FactoryConfig”buttonintheConfigurationmenuwillreturnthescreentothe
following settings.Out of the box, the Series ULS will output a 4‐20 mA output that is maximized for its
operationalrange.
 SeriesULSS–4mA@4.1’(1.25m)awayand20mA@2”(5cm)awayfromsensor.
 SeriesULSM–4mA@8.2’(2.5m)awayand20mA@4”(10cm)awayfromsensor.
 SeriesULSL–4mA@18.0’(5.5m)awayand20mA@8”(20cm)awayfromsensor.
FactoryDefaultsTable

TestingtheTransmitter


1. Connectamultimeterinserieswiththeblackwiretoreadthecurrentoutput.
2. Verify that the current increases (tank filling) and decreases (tank emptying) appropriately in the
calibratedspan.
3. Ifnot,carefullyobserveandattempttocorrelate
anyinstallation,levelorapplicationeventformore
specifictroubleshootingdirection.
