Installation Sheet

ManualsBrandsDXV ManualsPlumbingDXV Modulus 32" x 60" Rectangular Shower Base with Single Threshold and Left Drain

- 1 -

INSTALLATION INSTRUCTIONS

SAVE FOR FUTURE USE

Product names listed herein are trademarks of AS America, Inc.

755193-100 Rev. A (4/18)

Thank you for selecting DXV. To ensure this product is installed properly, please read these instructions carefully before you begin.

(Certain installations may require professional help.) Also be sure your installation conforms to local codes.

CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

DXV

Solid Surface Shower Base

Models: D16030STR, D16030STL, D16032STR,

D16032STL, D14836STC

RECOMMENDED TOOLS AND MATERIALS

Most of the procedures require the use of common tools and materials, which are available from hardware and

plumbing supply stores. It is essential that the tools and materials be on hand before work has begun.

The opening dimensions should be at least 1/8" larger than dimensions shown.

For the best ﬁt, the opening measurements should be veriﬁed against the actual shower base received.

ROUGH-IN REFERENCES

Tools Materials

• Level

• Pencil

• Square

• Tape Measure

• Pipe Wrench

• Slip Joint Pliers

• Screw Driver

• Standard Woodworking Tools

• Personal Safety Equipment

• Caulking Gun

• Silicone Sealant

• Drop Cloth

• Mortar Mix or Grout

FRONT

RIGHT SIDE

TOP VIEW

D16030STR / D16030STL

FRONT

TOP VIEW

48"

(1219 mm)

24"

(610mm)

RIGHT-HAND

OUTLET

CENTER

OUTLET

LEFT-HAND

OUTLET

3-3/8" (86 mm)

60"

(1524 mm)

14-7/8"

(378mm)

14-7/8"

(378mm)

30"

(762 mm)

2-1/2"

(64 mm)

6-1/2"

(165 mm)

6-1/2"

(165 mm)

(25 mm)

2-1/8" (54 mm)

THRESHOLD DEPTH

FRONT

TOP VIEW

D16032STR / D16032STL

D14836STC.XXX

FOR ALL MODELS

RIGHT-HAND

OUTLET

LEFT-HAND

OUTLET

3-3/8" (86 mm)

60"

(1524 mm)

16"

(406 mm)

16"

(406 mm)

32"

(813 mm)

36"

(914 mm)

6-1/2"

(165 mm)

6-1/2"

(165 mm)

6-1/2"

(165 mm)

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS DXV Solid Surface Shower Base Models: D16030STR, D16030STL, D16032STR, D16032STL, D14836STC Thank you for selecting DXV. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.
PAGE 2
1 MARK STUDS 3-1/2" ABOVE LEVEL SUBFLOOR Ensure that the floor and stud walls are square and plumb on a level floor as shown in Figure A. Provide a 6" x 6" (152 x152 mm) opening in the floor for the drain and refer to the product chart for actual drain location.The lower portion of the drain mount must fit into the 6"x 6"opening. Check by dry fitting the shower base in the final location. Draw a line 3-1/2" (89 mm) above the level subfloor on the wall studs at each side of the opening.
PAGE 3
4 After the bedding material has been poured and before it sets, lower the shower base into position with the drain assembly sliding over the waste pipe Figure C. It will be necessary to "rock" the shower base until the top of the tile flange aligns with the lines drawn on the stud walls from Step 1. Make sure the apron is contacting the rough floor along the entire length of the shower base and ensure that the base is level in two directions as shown in Figure D.
PAGE 4
In the United States: DXV One Centennial Avenue Piscataway, New Jersey 08855 Attention: Director of Customer Care For residents of the United States, warranty information may also be obtained by calling the following toll free number: (800) 227-2734 www.DXV.com In Canada: DXV 5900 Avebury Road Mississauga, Ontario L5R 3M3 Canada Toll Free: 1-800-387-0369 Local: 905-306-1093 Fax: 1-800-395-1498 www.DXV.ca -4- In Mexico: DXV Via Morelos 330 Col.