Installation Sheet

- 3 -

7302420-100 Rev. A (6/2020)

Screw vanity into cross support behind the wall to rmly attach

vanity to the wall.

Place assembled combination of marble counter top and lavatory

onto top of vanity. Ensure marble top is ush to rear of wall and

centered left to right over the vanity and check level front to back,

left to right. Also check that drain and water supply lines correctly t

when drawers are installed.

Remove marble counter top and apply a generous amount of ad-

hesive on surface of vanity where the marble counter top will sit to

hold top in place.

Carefully place marble top back onto vanity and position in place as

noted above. Remove any adhesive that may run out.

Connect drain and water supply lines and check for leaks.

Replace all 3 drawers. NOTE: If drawers do not close smoothly or

correctly, they may require an adjustment which can be done by

moving the white tabs next to the orange tabs in or out which will

raise or lower the drawer on the rails or tracks.