Installation Sheet

ManualsBrandsDXV ManualsPlumbingCossu 1.28 GPF One Piece Elongated Chair Height Toilet with Right Hand Lever - Seat Included

- 16 - - 1 -

INSTALLATION INSTRUCTIONS

SAVE FOR FUTURE USE

Product names listed herein are trademarks of AS America, Inc.

7302029-100 Rev. F (4/18)

RECOMMENDED TOOLS AND MATERIALS

Most of the procedures require the use of common tools and materials, which are available from hardware and plumbing

supply stores. It is tessential that the tools and materials be on hand before work is begun.

Thank you for selecting DXV. To ensure this product is installed properly, please read these instructions carefully before you begin.

(Certain installations may require professional help.) Also be sure your installation conforms to local codes.

CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!

NOTE: Pictures may not exactly deﬁ ne contour of china and components.

St. George

/ Wyatt

/ Cossu

™

One-Piece Toilets - 1.28 gpf / 4.8 Lpf

St. George - Model D22000C101

Wyatt - Models D22005C101 - Left-Hand Trip Lever

D22005C102 - Right-Hand Trip Lever

Cossu - Models D22015F101 - Left-Hand Trip Lever

D22015F102 - Right-Hand Trip Lever

GasketWax Ring

Regular Screwdriver

10'

Level Flexible Supply Tube

Closet Bolts

Putty Knife

Tape Measure

Hacksaw

SealantAdjustable Wrench

a. Close toilet supply valve and  ush tank completely. Towel or sponge remaining water from tank and bowl.

b. Disconnect and remove supply line. NOTE: If replacing valve, ﬁ rst shut off main water supply!

c. Remove old mounting hardware, remove toilet and plug  oor waste opening to prevent escaping sewer gases.

d. Remove closet bolts from  ange and clean away old wax, putty, etc. from base area.

NOTE: Mounting surface must be clean and level before new toilet is installed!

NOTE: Distance from wall to closet ﬂ ange

centerline must be as listed below:

IMPORTANT: Water supply on the wall is

required at 3-3/4" (95 mm) or 9" (299 mm)

from centerline of the toilet (see rough-in).

First suggested position is hidden behind

the toilet. The geometry of the toilet gives

space for this installation.

The second suggested position is next

to the toilet. Between these two positions,

the space for the supply between wall

and toilet is limited to 3-1/4" (95 mm).

In this case, check your supply and

hose dimensions.

REMOVE OLD TOILET

ROUGHING-IN DIMENSIONS: St. George 1.28 gpf / 4.8 Lpf One-Piece Toilet

Model D22000C101

ALL INSTALLATION PROCEDURES MUST COMPLY IN STRICT ACCORDANCE WITH APPLICABLE LOCAL

PLUMBING AND BUILDING CODES

C/L OF OUTLET

AND TOILET

MTG BOLTS

29-7/8"

(758 mm)

18-1/2"

(470 mm)

16-1/2"

(419 mm)

8-1/2"

(217 mm)

12"

(305 mm)

14-1/4"

(361 mm)

8-1/8"

(206 mm)

C/L OF SEAT POST

HOLES 5-1/2"

(140 mm) CENTERS

FINISHED

WALL

3-11/16"

(94 mm)

5/8"

(16 mm)

3-1/2"

(88 mm)

2-3/4"

(80 mm)

FINISHED

FLOOR

14-3/4"

(376 mm)

30-3/4"

(781 mm)

15"

(380 mm)

14"

(356 mm)

5-1/2"

(140 mm)

SUPPLY AS

REQUIRED

(position 2)

SUPPLY AS

REQUIRED

(position 1)

(152 mm)

(229mm)

3-3/4"

(95mm)

Summary of content (8 pages)

PAGE 1
INSTALLATION INSTRUCTIONS St. George® / Wyatt® / Cossu™ One-Piece Toilets - 1.28 gpf / 4.8 Lpf St. George - Model D22000C101 Wyatt - Models D22005C101 - Left-Hand Trip Lever D22005C102 - Right-Hand Trip Lever Cossu - Models D22015F101 - Left-Hand Trip Lever D22015F102 - Right-Hand Trip Lever Thank you for selecting DXV. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.
PAGE 2
3-7/16" The second suggested (87 mm) position is next to the 3-1/2" toilet. Between these (88 mm) two positions, the space for the supply between wall and toilet is limited to 3-1/4" (95 mm). In this case, check your supply and hose dimensions. CUBIERTA DE TANQUE C/L OF SEAT POST HOLES 5-1/2" (140 mm) CENTERS 18-1/2" (470 mm) 30-3/4" (782 mm) Cubierta de tanque, St. George √ SUPPLY AS REQUIRED (position 1 or position 2) 5004A-10G.XXX Tradicional asiento alargado, St.
PAGE 3
9 10 PARTE SUPERIOR BRAZO NIPLE MARCA DE NIVEL CRÍTICO ("C. L. ") DEBE ESTAR A 25 CM (1 pulgada) SOBRE EL TUBO DE REBOSE CUERPO DE LA VÁLVULA ALTURA AJUSTABLE CLIP EN “S” a. Ajuste el nivel del agua. El nivel del agua se debe ajustar hasta donde marca el tanque, regulando el flotador. b. Si la taza no realiza la descarga, puede ser necesario ajustar la cadena de elevación.
PAGE 4
9 10 CRITICAL LEVEL MARK ("C.L.") MUST BE 1" ABOVE OVERFLOW PIPE TANK LEVER Fig. 9A "S" CLIP FLOAT CUP a. Adjust water level. Water level should be adjusted to level indicated on tank by adjusting float cup. TUERCA ABERTURA DRAIN CENTER LINE SELLADOR ADJUSTABLE HEIGHT b. If bowl fails to siphon, an adjustment may be required with the lift chain. Simply remove the bead chain from the retainment clip (see Diagram 1) and take up slack on the chain, and reinsert on lift rod.
PAGE 5
INLET VALVE TANK COVER PARED TERMINADA Tank Cover, St. George √ 5004A-10G.XXX Traditional Elongated Seat, St. George √ 7381073-XXX0A Bolt Cap Kit √ 738835-XXX0A Trip Lever, St. George √ 7381125-400.0070A Universal Inlet Valve √ 738942-104.0070A Flush Valve Assembly with Flapper √ √ 7381043-402.0070A Flapper Assembly √ √ 735194-400.XXX Tank Cover, Wyatt 15-3/8" (390 mm) L/C DE AGUJEROS DE MONTAJE DEL ASIENTO 5-1/2 PULG.
PAGE 6
INSTRUCTIONS D’INSTALLATION MD St. George® / Wyatt® / Cossu™ Inodoros de una pieza - 1,28 gpf / 4,8 Lpf MC St. George / Wyatt / Cossu Toilettes monobloc - 1,28 gpf / 4,8 Lpf St. George -Modelo D22000C101 Wyatt - Modelos D22005C101- Palanca - mano izquierda D22005C102- Palanca - mano derecha Cossu - Modelo D22015F101- Palanca - mano izquierda D22015F102- Palanca - mano derecha St.
PAGE 7
DESCRIPTION 1.28 GPF St. George MD 2b MESURES RELATIVES AUX COMPOSANT 735193-400.XXX Couvercle de réservoir, St. George √ 5004A-10G.XXX Traditionnelles siège allongé, St. George √ 7381073-XXX0A Trousse de cache-boulons √ 738835-XXX0A Levier de chasse, St. George √ 7381125-400.0070A Universel Valve d'admission √ √ 738942-104.0070A Emsemble de chasse avec clapet √ √ 7381043-402.0070A Valve de chasse √ √ VALVE DE CHASSE CLAPET LEVIER DE CHASSE 735194-400.
PAGE 8
3 4 9 5 10 RÉGLAGES ARM TOP REFILL TUBE NIPPLE OUVERTURE ÉCROU RONDELLE TRONQUÉE LIGNE CENTRALE DE VIDANGE TANK LEVER CRITICAL LEVEL MARK ("C.L.") MUST BE 1" ABOVE OVERFLOW PIPE Fig. 9A FLOAT CUP BOULONS DE LA TOILETTE SCELLANT COLLERETTE DE PLANCHER RONDELLE EN CIRE Passer les boulons de la toilette dans lesouvertures de la collerette et glisser en place parallèle au mur. Renverser la toilette sur le plancher (p. ex.