Installation Sheet

- 4 -
11
7302031-100 Rev. C (6/17)
PARTS LIST
Repair parts are determined by toilet tank number which can be found marked inside tank.
NOTE: "XXX" represents color options. Specify when ordering.
ROUND
FRONT
COMBO
NUMBER
ELONGATED
COMBO
NUMBER
COMPONENT DESCRIPTION
D2205DA101
1.28 gpf
D2205CA101
1.28 gpf
D24005A.101.XXX Fitzgerald
®
TANK - 1.28 gpf (with valves and lever) √ √
7381344-200.XXX TRIP LEVER √ √
7381073-200.XXX0A BOLT CAP KIT √ √
7301494-0070A TANK COUPLING KIT #261 √ √
738916-100.0070A REFILL TUBE - 5 INCH √ √
735191-400.XXX TANK COVER √ √
738921-104.0070A FLUSHVALVE ASSEMBLY (HET) - 3 INCH (INCLUDES FLAPPER) √ √
7381043-400.0070A FLAPPER ASSEMBLY (HET) - 3 INCH √ √
738565-446.0070A FLUIDMASTER 400A VALVE INLET VALVE √ √
5004A.10G.XXX SLOW CLOSE TRADITIONAL ELONGATED SEAT √
5004B.10G.XXX SLOW CLOSE TRADITIONAL ROUND FRONT SEAT √
TROUBLESHOOTING
IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK SLOWLY, repeat Step 11.
IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF NON-USE,
it is a signal you are wasting water because:
• The end of the rell tube is inserted into overow pipe, below water level in tank.
Attach rell tube to overow pipe using "S" clip provided.
• The ush valve is leaking because it's worn, dirty or misaligned with tank ball or
apper (replace with a new apper). IF FILL VALVE WON'T TURN ON OR
SHUT OFF or REFILL OF TANK WATER IS SLOW after valve has been in
use for some time, Fluidmaster Model 242 Replacement Seal may be needed.
Go to our website at www.fluidmaster.com for more solutions to toilet problems.
LIFT ARM
FIRST
LIFT ARM
FIRST
LIFT ARM
FIRST
IMPORTANT: Always clear sand
and rust from system.
• Make sure water supply is off.
Remove valve TOP by lifting arm
and rotating top and arm 1/8 turn
counterclockwise, pressing down
slightly on cap.
• While holding a container over
the uncapped VALVE to prevent
splashing, turn water supply on
and off a few times. Leave water
supply off.
• Replace TOP by engaging lugs and
rotating 1/8 turn clockwise. MAKE
CERTAIN TIP IS TURNED TO THE
LOCKED POSITION. VALVE MAY
NOT TURN ON IF TOP IS NOT FULLY
TURNED TO THE LOCKED POS
For troubleshooting information please contact:
© 2001 Fluidmaster, Inc.
® Registered trademark of Fluidmaster, Inc.
30800 Rancho Viejo Road
San Juan Capistrano, CA 92675
[phone] [phone]
www.uidmaster.com
NOTE: Pictures are representative and may not exactly depict the flush valve.
Always use quality Fluidmaster repair parts when
maintaining your Fluidmaster products. Fluidmaster
shall not be responsible or liable for any damages
caused by products used with Fluidmaster valves
that were not manufactured by Fluidmaster, Inc.