Installation Sheet

- 1 -
INSTALLATION INSTRUCTIONS
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2013
7302189-100 Rev. A (3/15)
SAVE FOR FUTURE USE
RECOMMENDED TOOLS AND MATERIALS
Most of the procedures require the use of common tools and materials, which are available from hardware and plumbing,
supply stores. It is essential that the tools and materials be on hand before work is begun.
ROUGHING-IN DIMENSIONS:
• For reference
NOTE: Distance from wall to closet flange centerline must be as listed below:
IMPORTANT: Water supply on the wall is required at 3" (76 or 22 9mm) from centerline of the toilet (see rough-in). First
suggested position is hidden behind the toilet. The geometry of the toilet gives space for this installation. The second
suggested position is next to the toilet. Between these two positions, the space for the supply between wall and toilet is limited to 3-1/2"
(89 mm). In this case, check your supply and hose dimensions.
Thank you for selecting DXV by American Standard. To ensure this product is installed properly, please read these instructions carefully
before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes.
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE: Pictures may not exactly define contour of china and components.
ALL INSTALLATION PROCEDURES MUST COMPLY IN STRICT ACCORDANCE WITH APPLICABLE
LOCAL PLUMBING AND BUILDING CODES
!
D2203AA100: Oak Hill RH EL HET Combo,
12" Rough, Tank D24030A100 + Bowl D23030A100
D23030A100: Oak Hill RH EL Bowl (with seat)
D24030A100: Oak Hill HET Tank, 12"Rough
Oak Hill
™
1.28 gpf / 4.8 Lpf 2-Piece Toilet
30-13/16"
(783 mm)
9-7/16"
(240 mm)
18-1/2"
(470 mm)
16-1/2"
(419 mm)
18"
(457 mm)
32-15/16"
(836 mm)
FINISHED
FLOOR
14"
(356 mm)
11"
(279 mm)
15"
(382 mm)
12"
(305 mm)
7-3/16"
(183 mm)
3-11/16"
(94 mm)
3-5/8"
(92 mm)
11/16"
(17 mm)
1
REMOVE OLD TOILET
a. Close toilet supply valve and ush tank completely. Towel or sponge remaining water from tank and bowl.
b. Disconnect and remove supply line. NOTE: If replacing valve, first shut off main water supply!
c. Remove old mounting hardware, remove toilet and plug oor waste opening to prevent escaping sewer gases.
d. Remove closet bolts from ange and clean away old wax, putty, etc. from base area.
NOTE: Mounting surface must be clean and level before new toilet is installed!
Adjustable Wrench GasketWax Ring
Regular Screwdriver
10'
Level Flexible Supply Tube
Closet Bolts
Putty Knife
Tape Measure
Hacksaw
Sealant