Installation Sheet

- 2 -
5
7
6
INSTALL TOILET
INSTALL TOILET SEAT: Install toilet seat in accordance with manufacturer’s directions.
INSTALL TANK
a. Position toilet squarely to wall and, with a rocking motion, press bowl
down fully on wax ring and ange.
Alternately tighten nuts until toilet is rmly seated on oor.
!
CAUTION: DO NOT OVERTIGHTEN NUTS OR
BASE MAY BE DAMAGED!
b. Ins tall bolt covers:
1. Make sure that the bolt cover area on the toilet is clean and
dry (see gure). Use a dry piece of cloth or soap and water if needed.
2. Take plastic bolt cover and peel the brown protective lm off on both ends.
The adhesive part is now visible and ready to be placed on the toilet (see gure).
3. Gently place the bolt cover on the toilet area (see picture) and if everything
is aligned, push bolt cover rmly so it remains in place.
4. If not aligned, you can still take it off and put it back so it is aligned.
5. Repeat Step 3 for second bolt cover which is to be placed on opposite side of the toilet.
6. After 24 hours, the bolt cover adhesive has completely set off and if needed, you can
remove/replace as needed. The dual lock technology is now in place.
c. Smooth off the bead of sealant around base. Remove excess sealant.
a. Install large rubber gasket over threaded outlet on bottom of tank and lower
tank onto bowl so that tapered end of gasket ts evenly into bowl water inlet
opening, and tank mounting bolts go through mounting holes. Secure with
metal washer/nut combo.
b. With tank parallel to wall, alternately tighten nuts until tank is snugged down
evenly against bowl surface.
*USE INCLUDED TOOL, NUT DRIVER, OR DEEP SOCKET RACHET.
!
CAUTION: DO NOT OVERTIGHTEN NUTS MORE THAN REQUIRED FOR A SNUG FIT!
Install closet bolts in ange channel,
turn 90°, and slide into place 6"
(152 mm) apart and parallel to wall.
For Tanks/Bowls using Speed Connect System (Tank mounting bolts pre-installed).(152 mm) apart and parallel to wall.
Invert toilet on oor (cushion to
prevent damage), and install wax
ring evenly around waste ange
(horn), with tapered end of ring
facing toilet. Apply a thin bead
of sealant around toilet base.
a. Unplug oor waste opening and install toilet on
closet ange so bolts project through mounting holes.
b. Loosely install retainer washers and nuts. Side of
washers marked “THIS SIDE UP” must face up!
INSTALL CLOSET BOLTS INSTALL WAX SEAL POSITION TOILET ON FLANGE
2 3 4
7302189-100 Rev. A (3/15)
CLOSET
FLANGE
CLOSET
BOLTS
A
WAX RING
SEALANT
NUT
TAPERED
WASHER
FLANGE
CLOSET
BOLT
BOLTS
RUBBER
GASKET
TANK MTG.
BOLTS PRE-
INSTALLED
WASHER/
NUT
COMBO