Installation Sheet
- 3 -
M965495 Rev. 2.0 (7/18)
3
4
4a
MAKE WATER SUPPLY CONNECTIONS
TEST INSTALLED FAUCET
• Connect HOT water supply to LEFT INLET UNION (1)
and COLD water supply to RIGHT INLET UNION (2).
Pipe connections are 3/4" (19 mm) NPT. Use sealant
or Teon tape on pipe connections.
Do not solder directly to valve body.
• With HANDLES in OFF position, turn
on WATER SUPPLIES and check all
connections for leaks.
• Operate both HANDLES to ush water
lines thoroughly.
• Lift HAND SHOWER from HOLDER, direct
spray into tub. Lift TRANSFER KNOB to
check HAND SHOWER and HOSES for
leaks.
• Turn handles “off” and replace HAND SHOWER.
INSTALL VALVE BODIES and HANDLES
1-3/4''
(44 mm) MAX.
STOP RING
GROOVE
1
2
16
HOT
COLD
15
17
5
16
3
4
7
8
12
14
13
6
11
9
10
HOT
• Unpack valve assembly and remove HANDLE (10) by unthreading
SET SCREW (12). Unthread ROSETTE (9) and FLANGE (8)
removing them from VALVE BODY (2).
• Thread LOCKNUT (1) to bottom of VALVE BODY (2). Make sure
SPACER (3), BRASS WASHER (4) and RUBBER WASHER (5)
are installed.
• Insert VALVE BODY (2) through mounting hole from underside
of tub deck or mounting surface.
Note: VALVE BODY marked Hot is installed in the left Mtg. hole,
VALVE BODY marked Cold in the right when facing front of fitting.
Maximum mounting surface thickness is 1-3/4".
• Install STOP RING (6) onto VALVE BODY (2) if not in place. Install
O-RING (7) into groove in FLANGE (8).
• Thread FLANGE (8) ush against STOP RING (6). Thread
ROSETTE (9) onto VALVE BODY (2) until tight against it’s
internal stop.
• Align VALVE BODY (2) and from below tighten LOCKNUT (1)
to secure VALVE BODY (2).
INSTALL HANDLES
• Turn VALVES to off position. Align HANDLES (10) as shown or
as desired and install onto HANDLE ADAPTER (11). Tighten
SET SCREW (12) with HEX WRENCH (13) supplied. Push
PLUG BUTTON (14) into place.
HOSE CONNECTIONS
• Insert RUBBER WASHERS (15) into COUPLING NUTS (16) of
SUPPLY HOSES (17) and tighten making water tight connection.
Important: Loop SUPPLY HOSES (17) as illustrated so they do not kink.
3/4" X 3/4" (19 x 19 mm) NPT UNION
(NOT SUPPLIED)
HOT
3/4"
(19 mm) NPT
3/4"
(19 mm) NPT
HAND SHOWER
2
1
TRANSFER KNOB
IMPORTANT: It is strongly
recommended that
access be provided for
all enclosed
mechanical parts
to this system.