Installation Sheet

- 3 -
M965850 (8/17)
4
• Apply a bead of putty to underside
of FLANGE (1).
INSTALL POP-UP DRAIN
4b
• Place SEAL (1) with small end facing up into
TAILPIECE (2) and tighten against DRAIN BODY (4).
PIVOT ROD (3) opening in TAILPIECE (2) should
face the rear of the lavatory. Tighten LOCK NUT (5)
with channel locks.Do not over tighten.
1
4a
4c
1
3
4
2
5
3
2
1
5
4
5
• Assemble PIVOT ROD (1), PIVOT NUT (2), CLIP (3) and SEAL (4)
as shown. Hand tighten PIVOT NUT (2) Drop STOPPER (5) into
drain. (For vandal proof drain rotate stopper so PIVOT ROD (1)
goes through EYE (6) of STOPPER (5). Make connection to
“P” TRAP.
• Remove one end of CLIP (3) from PIVOT ROD (1) by squeezing
ends together while sliding.
• Insert PIVOT ROD (1) into second or third hole in EXTENSION (7)
and reassemble CLIP (3). (EXTENSION (7) may need to be bent.)
• Adjust STOPPER (5)
height by repositioning
EXTENSION (7) and
tightening
THUMBSCREW (8).
6
5
2
4
1
8
7
3
• Drop FLANGE (1) into LAVATORY
DRAIN (2). From below assemble
RUBBER GASKET (3), METAL
WASHER (4) and LOCK NUT (5).
Do not tighten.
• Connect 1-1/4" O.D. tailpiece on
POP-UP DRAIN to waste outlet.
CONNECT DRAIN
WASTE
OUTLET
1-1/4" O.D.
TAILPIECE
6
CHECK OPERATION OF POP-UP
• Operate LIFT KNOB (1) to verify that STOPPER (2)
opens and closes.
Note: If STOPPER (2) does not open and close properly then
refer to the “troubleshooting section” of these instructions.
2
1