Installation Sheet

- 2 -

M965829 (4/17)

• Install SEAL (1) into groove of FAUCET BASE (2).

• Feed FAUCET SUPPLY TUBES (5) and SHANK (3) through mounting hole of lavatory or mounting surface.

• From below, Install RUBBER SEAL with RETAINING WASHER (4) and LOCKNUT (6) onto faucet SHANK (3). Before nal

tightening, faucet should be seated ush on mounting surface. Adjust faucet so that it is centered and covers mounting hole.

Tighten LOCKNUT (6) using a 15mm or adjustable wrench. Do not over tighten.

• Installation is the same for VESSEL FAUCET (7).

INSTALL FAUCET (LAVATORY AND VESSEL FAUCETS)

CAUTION

Turn off hot and cold water

supplies before beginning.

MOUNTING

SURFACE