Installation Sheet

- 3 -

WASTE

OUTLET

1-1/4" O.D.

TAILPIECE

M965816 Rev. 1.0 (7/17)

TEE ASSEMBLY

MAKE WATER SUPPLY AND WASTE CONNECTIONS

NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS NOT INCLUDED

AND MUST BE PURCHASED SEPARATELY.

• Connect water supply to VALVE BODIES (1,1A) with

1/2" IPS FLEXIBLE SUPPLIES (2) or 3/8" O.D.

BULL-NOSE RISERS (3). Use adjustable wrench to

tighten connections. Do not over tighten. Be careful

not to kink copper supply when bending. Use tubing

cutter to cut to proper length.

• Connect HOT water supply to inlet of left SHANK

and COLD water supply to right SHANK using sealant,

appropriate connectors, and COUPLING NUTS.

HOT

COLD

FERRULE

COMPRESSION

NUT

COUPLING

NUT

FLEXIBLE

SUPPLIES

3/8 O.D.

BULL-NOSE

RISERS

1/2" PIPE

THREAD

3/8 COMPRESSION

CONNECTION

• Apply a bead of PUTTY to underside of

DRAIN BODY FLANGE (1).

• Feed DRAIN BODY (1)) down through lavatory.

• Assembly GASKET (2) WASHER (3) and LOCKNUT (4)

onto DRAIN BODY (1). Tighten LOCKNUT (4) rmly.

• Assembly TAILPIECE (5) to DRAIN BODY (1).

• Connect 1-1/4" O.D. tailpiece on POP-UP DRAIN to waste outlet.

DRAIN INSTALLATION

CONNECT DRAIN

PUTTY