Owner's Manual

GT 90D T r eadmill
6
#90 . 13mm W rench
#99. 5/16”x1/2” Hex Head
Bolts (8pcs)
#100. Ø 5/16” × Ø 18 × 1.5T
Flat W ashers (8pcs)
1. T ake the treadmill deck out of the box and place it on level
and clean ground.
Har dw ar e S tep 2
L e f t and Ri ght U pr i ght s
GT 90D Assembly Instructions
1
Remove Deck From Box
2
1. You may need assistance holding the Uprights (No.4/5) for this step.
2. Connect the Computer Cable (Middle) (No.54) to the Computer Cable (Lower) (No.55)
then insert Right and Left Uprights (No. 4/5) into the Frame Base (No.2) and use the
13mm Wrench (No.90) to tighten 8 Hex Head Bolts (No.99) and 8 Flat Washers (No.100).
Be careful not to pinch the Computer Cables as this may cause damage to them.