Use and Care Manual

Sun Paints & Coatings • 4701 East 7th Ave • Tampa, FL 33605-4701
Phone: [phone] • Facsimile: 813-367-0263 • www.suncoatings.com
F-14
R-1
DYC9050
POOL DECK WATERBORNE ACRYLIC STAIN
9050 Data Sheet
CHARACTERISTICS
Dyco 9050 Pool Deck Waterborne Acyclic Stain is specically for-
mulated for use on Pool Deck surfaces with a low sheen and
hard protective nish. May be applied to old deck paints if rmly
bonded to the deck surface. Self priming when applied to bare
concrete pool deck surfaces. Easy to use and cleans up with
warm soap and water.
RECOMMENDED USES
•
New Concrete Pool or Patio Decks
•
Previously Painted Pool or Patio Decks
•
New Kool Deck Surfaces
FEATURES/BENEFITS
•
Adheres to Bare or Painted Concrete Surfaces
•
Select from Light to Mid-Range Colors
•
Fast Drying and Easy to Apply
•
Resists Cracking and Peeling
•
Resists Mildew
•
Resists Fading
•
Easy Soap and Water Clean Up
RECOMMENDED PRIMERS
•
Previously Painted Decks - #9040
SPECIAL NOTES
Existing painted surfaces must be cleaned and de-glossed. Not
recommended for wood decks or vehicular trafc.
SLIPPERY WHEN WET
If the surface to be coated is exposed to water from rain, sprin-
klers, pools or by other means or if the surface is an inclined
plane, such as a ramp or if concrete steps are being coated,
Dyco recommends mixing SKID GARD #45 at 0.2lbs per gallon.
If SKID GARD #45 is not avaliable, see your paint specialist for
a recommendation of a suitable aggregate to be used at 0.2lbs
per gallon.
FOR ADDITIONAL INFORMATION
See MSDS or call toll-free 1-800-282-7901.
TECHNICAL DATA
Vehicle Type ...................... Waterborne Acrylic
Finish/Sheen .................... Low
Solids by Weight ................ 42%
Solids by Volume ............... 30%
Viscosity ........................... 70 ± 2 KU
VOC
(less exempt solvents)
............. 50 g/L.
Weight per Gallon .............. 10.2 lbs/gal.
COVERAGE
175-225 S.F./Gal. @ 4 mils Wet; 1.0 mil DFT
(Actual coverage may vary depending on type of sub-
strate, and application method.)
COLOR
•
9050 Tint Base - Light and Medium Colors
KEY ATTRIBUTES
Application Temperatures: 50 - 110°F (10 - 43.33°C)
Application Tools: Roller or Airless
Dry Times: Touch - 1 Hour; Recoat - 2 Hours
(Dry Time Based on 77°F (25°C), 50% RH)
Thinner: Water Reducible
Clean Up: Warm Soapy Water