Use and Care Manual
Sun Paints & Coatings • 4701 East 7th Ave • Tampa, FL 33605-4701
Phone: 1-800-247-9691 • Facsimile: 813-367-0263 • www.suncoatings.com
F-14
R-1
DYC9050
POOL DECK WATERBORNE ACRYLIC STAIN
9050 Data Sheet
CHARACTERISTICS
Dyco 9050 Pool Deck Waterborne Acyclic Stain is specically for-
mulated for use on Pool Deck surfaces with a low sheen and
hard protective nish. May be applied to old deck paints if rmly
bonded to the deck surface. Self priming when applied to bare
concrete pool deck surfaces. Easy to use and cleans up with
warm soap and water.
RECOMMENDED USES
•
New Concrete Pool or Patio Decks
•
Previously Painted Pool or Patio Decks
•
New Kool Deck Surfaces
FEATURES/BENEFITS
•
Adheres to Bare or Painted Concrete Surfaces
•
Select from Light to Mid-Range Colors
•
Fast Drying and Easy to Apply
•
Resists Cracking and Peeling
•
Resists Mildew
•
Resists Fading
•
Easy Soap and Water Clean Up
RECOMMENDED PRIMERS
•
Previously Painted Decks - #9040
SPECIAL NOTES
Existing painted surfaces must be cleaned and de-glossed. Not
recommended for wood decks or vehicular trafc.
SLIPPERY WHEN WET
If the surface to be coated is exposed to water from rain, sprin-
klers, pools or by other means or if the surface is an inclined
plane, such as a ramp or if concrete steps are being coated,
Dyco recommends mixing SKID GARD #45 at 0.2lbs per gallon.
If SKID GARD #45 is not avaliable, see your paint specialist for
a recommendation of a suitable aggregate to be used at 0.2lbs
per gallon.
FOR ADDITIONAL INFORMATION
See MSDS or call toll-free 1-800-282-7901.
TECHNICAL DATA
Vehicle Type ...................... Waterborne Acrylic
Finish/Sheen .................... Low
Solids by Weight ................ 42%
Solids by Volume ............... 30%
Viscosity ........................... 70 ± 2 KU
VOC
(less exempt solvents)
............. 50 g/L.
Weight per Gallon .............. 10.2 lbs/gal.
COVERAGE
175-225 S.F./Gal. @ 4 mils Wet; 1.0 mil DFT
(Actual coverage may vary depending on type of sub-
strate, and application method.)
COLOR
•
9050 Tint Base - Light and Medium Colors
KEY ATTRIBUTES
Application Temperatures: 50 - 110°F (10 - 43.33°C)
Application Tools: Roller or Airless
Dry Times: Touch - 1 Hour; Recoat - 2 Hours
(Dry Time Based on 77°F (25°C), 50% RH)
Thinner: Water Reducible
Clean Up: Warm Soapy Water