Pull-Out/Down Kitchen Faucet Installation Instructions Diagram 1 <1.5” (38mm) <1.5” (38mm) Note: 1.25” (30mm) 2” (50mm) Your faucet is designed for a hole with a diameter of 1 1/4” (30mm) and a deck thickness of up to 2” (50mm). If a soap dispenser is provided, the soap dispenser hole should not be larger than 1 1/2”. Please shut off water valves before conducting faucet assembly.
Pull-Out/Down Kitchen Faucet Installation Instructions Diagram 3 1 2 Step 2: The short water line is HOT water, while the longer water line is COLD. Securely attach both HOT (1) and COLD (2) water hoses to the faucet. Diagram 4 2 1 3 4 5 Step 3: Re-install the shank (1) and base (2), if provided, and proceed to install the faucet through the deck mounting hole. Attach the gasket (3), washer (4) and mounting nut (5) onto the shank.
Pull-Out/Down Kitchen Faucet Installation Instructions Diagram 5 2 1 Step 4: After the faucet is properly positioned, thoroughly tighten the screws on the mounting nut to secure the faucet in place. Should your faucet have a pull-out hose, attach the end of it (1) to the line converter (2). Diagram 6 1 Screw 2 Step 5: If a weight is provided as a component of your faucet’s assembly, disassemble it with use of a Phillips screwdriver.
Pull-Out/Down Kitchen Faucet Installation Instructions Diagram 7 Step 6: During faucet installation, filings, chips, and other debris can fall into the plumbing pipes. This debris can damage the internal faucet surfaces which can cause leakage. Before turning on the water valves, make sure the faucet handle is in the open (On) position in order to thoroughly flush out debris.
Pull-Out/Down Kitchen Faucet Installation Instructions Diagram 9 Step 8: After the water valves are turned on, let water filter through the faucet for 30 seconds. Evaluate all connections for leakage. After this process is complete, you may proceed to use your new faucet.
Soap Dispenser Installation Note: Soap Dispenser is not included with all faucets Diagram 1 5 4 2 3 1 Step 1: Remove soap canister (1), gasket (2) and mounting nut (3) from the soap dispenser’s shank (4). Place the soap dispenser (5) into the deck opening. From underneath the sink deck, attach the Gasket and mounting nut onto the faucet shank. Before tightening and securing the mounting nut, make certain the soap dispenser is properly positioned.
Manufacturer Limited Warranty All Dyconn Faucet products are manufactured and tested with the highest quality standards and rigorous quality control process. This warranty is limited to the non-commercial use of Dyconn Faucet products purchased and installed in the United States and Canada.
