Faucet Installation Diagram 1 2 1 3 4 6 5 Step 1: Shut off water supply. Remove old faucet. Step 2: Remove screws (1) on handles (2), pull off the faucet handle, then unscrew the handle base (3) and set all aside, including the gasket (4). Leave the mounting nut (5) on faucet handle shank (6), but screw it all the way to the bottom.
Diagram 2 A. 7 5 4 3 6 2 1 B. Step 3: A. Insert the faucet handle shank (1) with mounting nut (2) through the deck handle mounting hole from underneath the sink. Apply gasket (3) onto the top of the shank and screw on the faucet handle base (4), then reattach handle (5) onto valve connector (6). Screw handle base (4) until it connects with faucet handle (5) on the shank. B. Do not over tighten the handle base to the faucet handle, as it will prevent the handle from turning smoothly.
Diagram 3 1 2 4 3 5 Step 4: Place faucet spout (1) with base (2) and gasket (3) through the top of the sink mounting hole. Secure the spout with washer (4) and nut (5). Note: If sink is uneven, use silicone under the gasket. Diagram 4 1 Step 5: Install splitter (1) onto the faucet spout shank. Note: You might want to consider using plumbers tape for added protection against leakage. Ensure the splitter is securely tightened and that the splitter openings are facing left and right.
Diagram 5 1 1 Step 6: Install hoses (1) from each handle shank onto the spout splitter. Note: It is advisable to consider using plumbers tape for added protection against leakage. Diagram 6 1 1 Step 7: Connect valve hoses (1) (not included; sold separately) from your water supply valves onto the bottom of each handle shank. Connect the hot water valve to the left handle shank and the cold water valve to the right handle shank.
Pop-Up Installation Diagram 1 1 2 3 4 6 5 Step 1: Remove stopper (1) and flange (2) with plastic washer (3) and gasket (4). Screw nut (5) all the way down. Push the black gasket (6) down. Diagram 2 1 4 2 3 5 Step 2: Apply silicone to underside of the flange (1). Insert body (2) into sink. Add gasket (3) and add washer (4). Screw flange onto body. Pivot hole (5) must face back of sink. Tighten nut/gasket, clean excess silicone.
Diagram 3 3 4 5 6 7 1 2 Step 3: Remove pivot nut (1). Install horizontal rod (2) and stopper (3) as removable (4) or non-removable (5). Hand tighten pivot nut (1). Attach horizontal rod to strap (6) using clip (7). Diagram 4 1 1 3 2 4 Step 4: Insert lift rod (1) through faucet and into strap (2). Tighten screw (3). Connect assembly to drain (4).
Manufacturer Limited Warranty All Dyconn Faucet products are manufactured and tested with the highest quality standards and rigorous quality control process. This warranty is limited to the non-commercial use of Dyconn Faucet products purchased and installed in the United States and Canada.