Installation Guide

Install bidet
7 8
Be sure the bidet fixed as complete then left bidet to fit it
on correct position.
Install bidet
Push the product slip into fix bracket
and left bidet to send it into fitter
place
Notice: please don't forget the
power cable between the toilet
and bidet.
connect inlet pipe
Turn on inlet valve after connected, please check the connector
part leakage or not.
Connect T valve
1、Take out clip from connector of T valve.
2、Hold on PE Inter to push it towards
connector of T valve.
3、Reinstall clip to original position.
Connect bidet
1、Take out clip from connector
at the side of bidet.
2、Hold on PE inter to push it
towards connector of bidet.
3、Reinstall clip to original
position.
Flush tank
T valve
PE inter
Valve
Preparation for water supply and Test for operation
1、Insert electric plug into the socket.
2、When the indicator light is on, all indicator lights are
shining, at the same time, water flows into the inner
water tank, the process will cost about 11s.
Then water sprays out from the nozzle.
All indicator lights are off with a sound“Di”for once.
3、Press the power button on toilet or on remote
controller, then the power indicator light is
on, and the toilet is in the condition of work.
4、Adjust temperature of water and toilet seat to
appropriate condition
5、Follow the instructions to operate, press buttons as
told, and test every action.
Install the Remote Control Holder
Please see below picture
The bracket of remote control
Paste the tape on the backside
of remote control
Wall
Notice:clean the installation position before pasting and
Press the tape down fully and evenly when positioning.
While after pasting,do not touch the holder within 15 minutes.
Stick remote control and wall
by double side tape