Installation Guide

2.Remove the filter.
Unscrew the cover of the filter by straight screwdriver or one-yuan coin and
then pull out the cover as below:
3.Clean the filter.
Get the filter out and clean it thoroughly.
Flush off dirt or clean the filter by toothbrush.
Notice: Do not use any cleaning agents. Clean it with water only.
Do not crush the filter when cleaning in case of distortion.
4.Reattach the filter
Reinstall filter based on the removal sequence.
Notice: Do not open the shutoff valve before confirm there's no water leakage
after installation.
Cleaning and Maintenance
Cleaning the Toilet Bowl
Do not use corrosive solvents to clean the outside of the toilet, such as banana oil, benzene,
decolorizer, cleaner, and diluter. Also do not use water to rinsing the equipment as this may
cause short circuits,resulting in a fire.
Pull out the plug before cleaning in case that plug or the outlet gets wet by water.
Scrub the bowl unit gently by soft cloth. If it is very dirty, get the cloth wet and clean the unit
by neutral agents.
Cleaning and Maintenance the Nozzle
Press Nozzle Cleaning Button and water sprays out. Press the button a second time then the
rear nozzle extends and press again, feminine nozzle extends too.
Clean the nozzles with brush.
Replacing the Nozzle
Hold the front end of the nozzle tip and turn it counterclockwise
when nozzle extends. Then pull out of it. Replace the tip, insert
it into the nozzle and turn it clockwise.
**Do not force the nozzle tip out or bend it.
Cleaning the filter
When the water pressure is too low or insufficient, please clean the filter.
Notice: Do not remove the filer without closing the
shutoff valve.otherwise water will spray out.
1.Close the shutoff valve and stop water supply.
17 18