Installation Guide

Gasket
Connecting inlet water
1. Before installation, pls connect the angle valve with the pipe
2.Open the angle valve to let the dirty water come out until
the clean water come.
3. Connect the inlet water pipe with angle valve
4. Open the angle valve to check if all connector without leaking.
Position the toilet
Please check that walls and floors in
the toilet room are finished construction
and there is enough space pre-arranged
for sewage, electric wires and water lines.
Also please confirm the distance from the
closet flange centerline to the fished wall
fits for the . And the water supply rough in
pressure should be within a range of
0.1MPa (dynamic)-0.75Mpa (static).
While the water supply temperature
should be within a range of 5℃-35℃.
Notice: Please confirm the water inflow is greater
than 18l/min, otherwise it may not be performed.
Wall
Rough in
Drain Outlet
Installation Guide
Toilet inlet pipe connector
Inlet stainless
steel hose
Angle valve
Installation environment
Toilet bowl installation
Connect the water pipe
5 6