Installation Guide

Install the Remote Control Holder
Please see below picture
The bracket of remote control
Paste the tape on the backside
of remote control
Wall
Notice:clean the installation position before pasting and
Press the tape down fully and evenly when positioning.
While after pasting,do not touch the holder within 15 minutes.
Stick remote control and wall
by double side tape
Inside of
toilet bowl
Silica gel
Installation and Operation Precautions
1.Do not get toilet with cement or mortar inside as this may cause
cracking due to the condensation and expansion when installation.
2.Do not flush things that get toilet clogged easily, such as newspaper,
diapers, and sanitary napkins.
3.Do not use the toilet under 0℃ otherwise it may result in ceramic shell
cracking because of the expansion when water congeals into ice.
4.Do not strike the ceramic shell in case of damage or water leakage.
5.Clean the ceramic surface by nylon brush and soap-suds or neutral
cleaning agent. Do not use steel brush and strongly corrosive liquids
as it may damage the surface and corrode pipes.
Declaration: Damages due to improper installation or operation, company
will assume no responsibility.
1.Check if the blow off pipe is ok and the ground is clean before you
install
2.Put the Gasket on the blow off pipe hole..
3.Put the toilet on the ground and connect the blow off pipe, adjust
the position, make sure the seal ring is workable.
4.Smearing silica gel on the bottom of toilet bowl.(See the picture below)
5.Clean the ground, pls do not use the toilet after smearing silica gel
(Silica gel solidify need around 24hrs), keep the toilet bowl away
from water more than 24 hrs.
Outside of
toilet bowl
Position the toilet
7 8