Installation Guide

5
Step 2: Attach both water hoses to the faucet by screwing them into the two internal
ports located inside the base of the faucet. The red/blue indicator on the
side of the handle illustrates the hot water hose (red) is attached to the left
port while the cold water hose (blue) is attached to the right port.
Step 3: Re-install the shank (1) and base (2) and proceed to install the faucet and
hoses through the deck mounting hole. Attach the gasket (3), washer (4) and
mounting nut (5) onto the shank. Be sure the large side of the mounting nut
is facing up, with the screws facing upward.
Diagram 4
Diagram 3
Installation Instructions
1
2
1
2
2
3
5
4