Faucet Parts & Accessories You may need the following tools/materials Valve Hoses (included) Pliers Screw Driver Silicone 2 Wrench Plumbers Tape
Product Dimensions Product dimensions for model: (FL003-A8BN) Hudson - 12 ½” Contemporary Brushed Nickel Vessel Faucet.
Product Dimensions Product dimensions for model: (VS1H07-ORB) Rogue - Modern Oil-Rubbed Bronze Bathroom Faucet 4
Product Dimensions Product dimensions for model: (VS1H08-ORB) Kern - Modern Oil-Rubbed Bronze Bathroom Faucet 5
Installation Instructions Diagram 1 1.25” (30mm) 1.5” (38mm) Note: Your faucet is designed for a hole with a diameter of 1 1/4” (30mm) and a deck thickness of up to 1 1/2” (38mm). Diagram 2 2 1 3 4 5 Step 1: Unscrew the shank (1) from the faucet (if it is connected) and place it to the side, along with the faucet base (2), gasket (3), washer (4) and mounting nut (5).
Installation Instructions Diagram 3 1 2 Step 2: Attach both water hoses to the faucet by screwing them into the two internal ports located inside the base of the faucet. The red/blue indicator on the side of the handle illustrates the hot water hose (red - 1) is attached to the left port while the cold water hose (blue -2) is attached to the right port. Diagram 4 2 1 Step 3: Attach the shank (1) and base (2) and proceed to install the faucet through the deck mounting hole.
Installation Instructions Diagram 5 1 2 3 Step 5: Install the rubber gasket (1), washer (2) and the mounting nut (3) onto the faucet shank. Tighten the screws on the mounting nut to secure the mounting nut and the faucet in place. Be sure the large side of the mounting nut is facing up and the screws are pointing upward. Diagram 6 Step 6: During faucet installation, filings, chips, and other debris can fall into the plumbing pipes.
Installation Instructions Diagram 7 Step 7: Connect both water hoses onto the respective water valves (we recommend using plumbers tape to prevent leakage). Turn on the water valves. Diagram 8 Step 8: After the water valves are turned on, let water filter through the faucet for 30 seconds. Evaluate all connections for leakage. After this process is complete, you may proceed to use your new faucet.
Manufacturer Limited Warranty All Dyconn Faucet products are manufactured and tested with the highest quality standards and rigorous quality control process. This warranty is limited to the non-commercial use of Dyconn Faucet products purchased and installed in the United States and Canada.